Waveware Call Manager Bedienungsanleitung PDF herunterladen (Seite 25)

STEP 9 – Register Call Devices – Wired Call Systems

Configuring the “Wired Call System Input Port”

Configuration for use as a Wired Call Device - “Contact Closure” Device

Choose the “Wired System Input Port”. See Fig. 39-1 “B”

To “Register Call Devices” simply “Trigger” the Device and wait until you see it on the Screen. See Fig. 39-1 “A”

NOTE: Trigger one Device at a time and wait a Few Moments until the System “Acknowledges” the Device.

Fig. 39-1

In this Example the Device is being used with a Contact Medical Device.

When the Resident Pushes the Call Button on the Call Cord, the Device is

Triggered and will send out a Signal to the Call Manager Software which sends a

Alert Message out to the Assigned Recipient (Pager or Email Address).

Fig. A:

Trigger the Wired Call

Device and wait a Few

Moments.

The New Device should be

Displayed on the Screen.

After the Device is Shown,

you can Choose:

-The “Device Type”

-The “Room”

Do this for Every Device

Type Registered.

Note: You can Assign the

Room at a Later time, if you

wish.

Fig. B:

Choose One:

-Call System Input Port

-Inovonics EN Wireless

System Input Port

Here in this Example we are

Working with the Call

System Input Port to

This Device Type is a Call

Cord, which Normally works

with a Contact Device.

You can also Assign an

“Installer” Pager, to be used

for Testing during this Time.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 49 50

Keine Kommentare

Waveware Call Manager Bedienungsanleitung Seite 25