WaveWare Apollo T-2000 Technical Information PDF herunterladen (Seite 76)

Certification Manual

- 76 -

o Default is “Normal”

 Programmable Flow Control Signaling, Accommodates a variety of methods of

busy terminal signaling. Choose either:

o None

o Hardware (CTS)

o Software (XOFF/XON)

o Alt Hardware (CTS gets asserted before message response)

o Alt Software (XOFF is output before message response)

o Default is “Hardware”

Transmitter Duty Cycle

Transmitter Duty Cycle % values can range from 0 to 100. 0 and 100

values cause the duty cycle management function of the encoder to be

disabled. Any value from 1 to 99 causes duty cycle management function

to be enabled. The lower the number, the greater the delays between

transmissions caused by the encoder, to accommodate the duty cycle

requirements of specific radio models attached to the WaveWare paging

encoder. If there are concerns about the duty cycle requirements of a

particular radio, duty cycle values of 33, 50, or 66 are reasonable numbers

to consider using.

Max Messages per Batch

The Max Messages per Batch value can range from 1 to 32. The

WaveWare paging encoder supports batch paging, where multiple

messages can be included in a single key up cycle on a radio. Batch

paging allows more efficient use of the radio and delivers messages

quicker, because one preamble sequence is delivered at each “Key-up” of

the radio and multiple pager IDs and messages may be interspersed in a

single transmission cycle. Optimum message batching occurs when all

pagers operate with the same data rate, such as 512 bps (bits per second).

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 113 114

Keine Kommentare

WaveWare Apollo T-2000 Technical Information Seite 76